K Series K20 Billet Shifter Base Plate
Billet Shifter Base Plate is designed to install an RSX Type-S or comparable shifter box without cutting a hole in the exhaust tunnel of the chassis. This setup is preferred by many racers, esp. road course racers, because it mounts the shifter higher in the vehicle, keeping it closer to the driver and the steering. It also leaves a lot more room below the car for large exhaust systems.
The Shifter Base Plate was designed to route your shifter cables inside the car. Generally users set them up to exit through the heater hose hole in the firewall. Note that we assuming that the heater core has been deleted on most race cars. We also want users to be aware that this shifter setup does not clear any interior panels or center consoles on any chassis.
We Also Recommend
1.8T 3" Catless Downpipe | MK4 VW GTI Jetta Golf | AWW, AWP, AWD
1.8T 3" Catless Exhaust System MK4 VW GTI Jetta Golf GLI
SAI / EVAP Resistor Kit 3 piece N80 N112 N249 MK4 1.8T, B5 2.7T, B6 1.8T
SAI / EVAP Resistor Kit 5 piece N75 N80 N112 N249 VVT MK4 1.8T, B5 2.7T, B6 1.8T