1.8T Injector Harness Wire Tuck Kit
Part#: INJ-KIT
Product Description:
Ready to clean your stock 1.8T engine bay? This extension harness is your answer!
Made from high quality temperature resistant wiring. This kit allows you to tuck the 1.8T injector harness with out intensive modifications
Normally the injector harness is to short to tuck under the intake manifold which requires splicing and cutting of the factory harness which creates
possible high resistance codes, and improper signals sent from ECM to injectors. Plug and Play install professional installation is not required.
**NOTE: Some VW's have Round IAT sensors, some have Square. Please verify your sensor and select from the IAT sensor connector options.
Product Disclaimer:
Emissions Equipment Tampering Warning: In many states, tampering with your vehicle’s emissions equipment is unlawful. Our products are designed and sold for sanctioned off-road/competition non-emissions controlled vehicles only and may never be used on a public road or highway.
Using our products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists (more information can be found on the SEMA Action Network website www.semasan.com/emissions for state-by-state details in the USA).
CARB-Restricted Areas: CARB-Restricted products, will not be shipped to state of California under any circumstatences.
Official Air Resource Board Link: ARB State Adoption Link
Customer Responsibility: It is the responsibility of the installer and/or user of this product to ensure compliance with all applicable local and federal laws and regulations. Please check with your local vehicle authority before purchasing, using, or installing any of our products.
By proceeding with the purchase and use of our products, customers affirm their commitment to adhere to the terms outlined in this comprehensive product disclaimer. We reserve the right to update this disclaimer as necessary.
