K20 K24 K-Swap Conversion ECU Harness for EF Civic
A K-swap conversion harness is a must-have part for any K-series engine swap. The harness is required to join up the factory K-series engine harness to the factory dash harness of the swapped car. It is designed integrate the K-series ecu and all of the related electrical functions get them operating properly. Functions like the fuel pump, tach, speedo, starter signal, O2 sensors, etc.
Our harness harness is 99% plug and play and takes very little time to install. The harness is constructed with quality mil-spec wire and finished with a nice clean looking mil-spec nylon sleeving for protection. No Instructions included.
***Professional Installation is recommended.
The end result is a very high quality conversion harness at the best possible price. Several applications are available so get yours to make sure your K-swap is wired up right!
- This harness works with all USDM / JDM 02-04 wiring harnesses including, K20A, K20A2, K20A3.
- This harness is wired to use the factory wideband O2 sensor so European customers using the UKDM K20A/K20A2 wiring harness will need to convert the harness to use the narrowband type sensor.
- This harness does NOT work with any 05-06 OR K24 engine wiring harnesses.
We Also Recommend
SAI / EVAP Resistor Kit 3 piece N80 N112 N249 MK4 1.8T, B5 2.7T, B6 1.8T
SAI / EVAP Resistor Kit 5 piece N75 N80 N112 N249 VVT MK4 1.8T, B5 2.7T, B6 1.8T
4pcs Ignition Coil Connector Repair Plug Wiring Audi VW GTI Golf Jetta Passat